Snap Tools Spark
Check out these great Snap Tools Spark deals on ebay below
Snap Tools Spark
 SNAP ON CF 71 SPARK PLUG GAPPING TOOL US $39.00 
|
 Mac Tools Pliers Spark Plug Hose Snap Hose Black on Red Handle Long MINT US $49.99
|
 Snap On CF 72 Spark Plug Pliers Gapper Gapping Tool Vintage US $30.00
|
 SNAP ON TOOLS 13 16 SPARK PLUG Socket 3 8 inch drive Model No S9704 D US $7.95
|
 Snap On Tools 18MM Spark Plug Tread Restorer TCS18 US $14.95
|
 SNAP ON TOOLS UNIVERSAL SPARK PLUG SOCKETS 3 8DR US $64.99
|
 1944 SNAP ON TOOLS BLUE CROWN HUSKY SPARK PLUGS BUELL Page w 9 Small Print Ads US $7.99
|
 SNAP ON TOOLS NEW UNUSED 6 PC 3 8DR ASSORTED SAE METRIC SPARK PLUG SOCKET SET US $229.99
|
 NOS Snap On Tools S9704H Spark Plug Socket Old Logo US $29.50
|
 Snap on 3 8 Universal Joint Deep Spark Plug Socket US $79.00
|
 Snap On Tools Spark Plug Universal Retention 5 8 6 Point 3 8 Dr US $30.00
|
 Snap On Tools Spark Plug Universal 13 16 6 Point 3 8 DR US $30.00
|
 USED SNAP ON TOOLS 3 8 SQUARE DRIVE SPARK PLUG SOCKET S9704E 206MM 13 16 US $5.20
|
 MAC tools and Snap On swivel spark plug sockets 3 8 drive 5 8 13 16 US $20.00
|
 SNAP ON TOOLS 3 8 DRIVE UNIVERSAL DOUBLE SWIVEL SPARK PLUG IMPACT 6 PT SOCKET US $27.00
|
 USED SNAP ON TOOLS SPARK PLUG WIRE PULLER SPECIALTY TOOL SBP1 US $8.99
|
 SNAP ON TOOLS 2PC 5 8 SPARK PLUG SOCKET SETS9706 AND S9706AFU US $34.99
|
 SNAP ON 3 8 DRIVE FLEXIBLE EXTENSION 6 PT 5 8 SPARK PLUG SOCKET FSXK320A USA US $9.50
|
 SNAP ON 3 8 DRIVE 13 16 2060mm MAGNETIC SPARK PLUG SOCKET S9715A USA MADE US $.99
|
where do you find the "Back Tap" spark plug re-threading tool?
I've been searching the web, and cannot find the "Back Tap" tool for sale in Ontario, Canada anywhere. I'm looking for the 12mm size. Snap On sells something like it but looks like only in the States. Any help appreciated.
If you can't find that particular tool you might try taking a spark plug to the hardware store and just purchase a tap the size of the spark plug. Match the thread pitch by laying the tap against the spark plug.
When re-taping the hole, put a light grease on the tap to catch the metal shavings and don't wind it in too far so that it falls into the cylinder,mark it with tape or something, the tap is longer than the hole is deep so don't over do it. Make sure the piston is down.
Related Snap Tools Spark Searches