Bearing Sliding Puller
Check out these great Bearing Sliding Puller deals on ebay below
Bearing Sliding Puller
 Blind Hole Pilot Bearing Gear Puller Slide Hammer Kit US $60.99 
|
 Slide Hammer Dent Puller Oil Seal Bearing Remover External Internal 2 3 Jaws Too US $64.25
|
 Slide Hammer Pilot Bearing Puller Auto Mechanics Tool US $39.50
|
 ATV Quad Motorcycle Automotive Metric Bearing Remover Puller Tool Slide Hammer US $94.95
|
 Slide Hammer Blind Hole Bearing Gear Puller Removal Tool Pilot Bearings Install US $56.99
|
 Blind Hole Bearing Slide Hammer Gear Puller Remover Set US $99.00
|
 SLIDING HAMMER BEARING DENT PULLER 5 PIECE SLIDE 13KG US $19.52
|
 Blind Hole Pilot Bearing Gear Puller Slide Hammer Kit US $999.99
|
 15 Piece Slide Hammer and Puller Set handles bushings seals sleeves bearings US $44.99
|
 Pilot Bearing Puller Remover Slide Hammer MADE IN THE USA US $46.99
|
 Rear Axle Bearing Remover Puller Slide Hammer set Automotive Tool Case New US $39.65
|
 15 Piece Slide Hammer and Puller Set handles bushings seals sleeves bearings US $45.99
|
 SLIDE HAMMER BLIND HOLE BEARING GEAR PULLER REMOVAL NEW US $199.99
|
 OTC 9 Way Slide Hammer Axle Bearing Dent Hub Puller Set US $92.00
|
 OTC1172 PULLER SLIDE HAMMER PILOT BEARINGS 1 2 TO 2IN US $79.31
|
 Pittsburgh Slide Hammer and Bearing Puller Set with Case NIP US $79.99
|
 Slide Hammer DENT PULLER OIL SEAL BEARING REMOVER tools US $64.99
|
 oem new mitsubishi tool eclipse slide hammer puller roller bearing mb992039 01 US $69.99
|
 K Tool International Speciality Puller Separator Tools US $65.99
|
 New 3 Lb Slide Hammer Blind Hole Bearing Puller Set US $69.99
|
2004 Lincoln Navigator: Can't get the RF rotor off to replace it. How do you pull it off???
The caliper is off. I have tried to beat the rotor off with a rubber hammer...no luck. There is a race(bearing) in the center held in by a stud,lock ring & nut. Will this need to be replaced as well? I have changed rotors before but never incountered this scenario. Do I need a puller, slide hammer? What am I over looking? Need input!! Thanks
You DO NOT need to remove the center axle nut on this application. If you do, you risk damage to the hub & bearing assembly. BIG $$. Simply remove the caliper and caliper bracket. Spray generous amounts of PB blaster or WD-40 to the area around the hub. SMACK the OUTER SIDE of the brake rotor until it breaks free of the hub to remove. The above poster is referring to vehicles that are 2WD. I have never heard of a 2WD Navigator. Hope this helps.
Related Bearing Sliding Puller Searches